Citrus Scrub ‘N Shine Directions

Directions – Citrus Scrub ‘N Shine – 00525FR

General Directions**

HARD AND WOOD FLOOR CARE
Cleaner and Restorer – Auto Scrub and Buff

  1. Dilute at 6 ounces per gallon (48 ml per liter) of water.
  2. With an automatic scrubber and red pad, scrub floor area and pickup.
  3. Allow floor to dry thoroughly.
  4. Burnish floor with high speed machine and appropriate pad (hogs hair for wood).
  5. Dust mop floor.

Cleaner and Restorer – Mop and Buff

  1. Dilute at 6 ounces per gallon (48 ml per liter) of water.
  2. With a mop and bucket, damp mop floor.
  3. Allow floor to dry thoroughly.
  4. Burnish floor with high speed machine and appropriate pad (hogs hair for wood).
  5. Dust mop floor.

Restorer – Spray Buff

  1. Dilute at 2-4 ounces per quart (64-128 ml per liter) of water.
  2. Spray fine mist on manageable area of floor (about 800 sq. ft./73 m2).
  3. Let stand for 5 minutes until slightly damp but not completely dry.
  4. Burnish floor with high speed machine and appropriate pad (hogs hair for wood).
  5. Flip pad and buff to high gloss.
  6. Dust mop floor.

HARD FLOOR CARE
Deep Scrub (prior to recoating)

  1. Dilute 8 ounces per gallon (64 ml per liter) of water.
  2. Apply with mop and scrub with single disk machine or apply and scrub with an auto scrubber and blue pads.
  3. Rinse floor thoroughly with Blue Concentrate (2 oz. per gallon/64 ml per liter) and allow to dry.
  4. Apply 1 to 2 coats of floor finish.

Stripper

  1. Dilute at 10-12 ounces per gallon (80-96 ml per liter) of cold water.
  2. Use conventional stripping methods.

RUBBER AND WOOD FLOOR CARE
Rubber/Wood Prep (prior to recoating)

  1. Dilute 8 ounces per gallon (64 ml per liter) of water.
  2. Apply product to floor in 200 ft² sections. Top scrub with maroon wood prep pad. Floor should be uniformly clean and mark-free.
  3. Pick up soiled solution and continue with 200 ft² sections until entire floor is deep cleaned.
  4. Rinse floor thoroughly with Blue Concentrate (2 oz. per gallon/64 ml per liter) and allow to dry.
  5. Apply finish following label directions.

** See label directions and SDS for complete usage and safety instructions.